For checking minimum wall thickness of pipes and tanks in Ex-hazardous areas.
With the 1071-Ex measurements of wall
thicknesses can be made quickly and accurately
in the range of 0.7 to 400 mm.
There are three different probes available
to cover this wide measuring range, each
of which can be easily and conveniently
changed inside the hazardous area.
Standard probe: 1.5 to 250 mm
Mini probe: 0.7 to 25 mm
Low frequency probe: 5 to 400 mm
Due to its compact size and operating
time of over 200 hours, this easy to use
instrument is essential whenever the
continuous supervision of minimum wall
thicknesses is required.
For example, it is possible to check the
thickness of protective coats or for the
erosion of pipe or tank walls even while
the plant is operating.
By using the limit value guides, minimum
and maximum values can be set and are
registered by an audible signal.
The calibration functionality of the instrument
means that adjustments can be
made to compensate for the type of material
being measured, this is done by one
of two ways:
1. Entering the sound velocity of the
2. Measuring a material with known thickness
and adjusting the instrument to
These adjusted parameters then stay in
the memory even when switching off the
instrument. Display resolution and sensitivity
are also fully adjustable and as with
all the other functions, are easily selected
from the straightforward menu.
Low frequency probe DSE 18 / 25 PB 1,5
Handle-collar for low frequency probe
Vulcollan films (10 pcs.) for DSE 18 /
25 PB 1,5
Mini probe DSE 4,2 / 4 PB 8
Vulcollan films (10 pcs.) for DSE 4,2 /
4 PB 8
ECHOTRACE ultrasound couplant gel