Home › Gas Analysers › Safety › Drager Polytron TX
Drager Polytron TX
Please note - Product designs and specifications are subject to change without notice. The user is responsible for determining the suitability of this product.
This product is now obsolete and has been replaced by the Polytron 5000.
The Drager Polytron TX is an economical, microprocessor-based gas detector for continuous
monitoring of toxic gases and oxygen in ambient air. Non-intrusive calibration and maintenance
is performed using a magnetic wand to access the software through the enclosure
window – no need to open the enclosure (and obtain special area permits) to perform
Easy to install
The enclosure provides two mounting
holes. For easy wiring, bezel and electronics
is one unit, and can be pulled out.
The two wire cable, fed through a sealed
conduit, is terminated in a pluggable
connector at the printed circuit board.
One man calibration
All setup and maintenance is performed
without opening the transmitter or
declassifying the hazardous area.
Tapping a magnetic wand at the three
buttons through the window gives full
access to the menu and the calibration
procedure. No need for an additional
High sensitivity, long term stability and no
false alarms are the hallmark of the new
and improved third generation of sensors.
Sensors are the keystones of any gas
detection system. Fastest response to the
target gas combined with minimal interference
by other gases or environmental
influences (no false alarms) as well as the
sensor life-time determine the reliability
and the operating cost of a system.
Features and Benefits
Simple software menu
Back To Last Page
We are open Monday to Friday, from 9.30 - 5.30 GMT.
|Keison Global. trading as:
Keison Products, VoIPon Solutions & 4Gon