Home › Gas Analysers › Safety › Drager Polytron 5000
Drager Polytron 5000
The microprocessor-based transmitter can be equipped with
various electrochemical DragerSensors. This way, you can detect
oxygen and various toxic gases in ambient air – reliably, quickly
and cost-effectively, as the Polytron 5000 is the result of more
than 40 years of experience in measurement technology.
PROVEN – AND STILL GETTING BETTER:
DRÄGER MEASUREMENT TECHNOLOGY
Drager has been developing and manufacturing
sensors and gas detectors for
industrial use for more than 40 years. And
with each new device generation, we drive
our measurement technology a bit further.
With the Polytron 5000, you will definitely
benefit from this experience and power of
short response times
low sensitivity to other gases or
changing ambient conditions
OPTIONAL: TWO MOUNTING SETS
FOR EASY FLANGE-MOUNTING
The housing has four mounting holes. Two
different mounting sets are available for
installing the Polytron 5000: a duct-mount
and a pipe mount set. This means that
the transmitter can be easily installed
anywhere – e.g., on a smooth wall, a pipe
or an exhaust duct.
QUICK AND EASY WIRING
The electronics and the bezel form a
single unit. Simply pull them out of the
housing. Then insert the two-wire cable
into the terminals. Finally plug the terminal
block into the PCB.
Aluminum or 316 L stainless steel
housing for the most extreme industrial
Extremely user-friendly software thanks
to a minimum number of menu items
Dräger Polytron 5000 aluminum enclosure without sensor; UL, CSA, ATEX ***) 4544120
Dräger Polytron 5000 316L stainless steel enclosure without sensor; UL, CSA, ATEX ***) 4544122
Dräger Polytron 5000 aluminum enclosure without sensor; general purpose 4544165
Please note - Product designs and specifications are subject to change without notice. The user is responsible for determining the suitability of this product.
Back To Last Page
We are open Monday to Friday, from 9.30 - 5.30 GMT.
|Keison Global. trading as:
Keison Products, VoIPon Solutions & 4Gon